Installation; Instructions; Installation Tools - Hytera DMR Owner's Manual

Installation

Before you install the radio in a vehicle, be sure to read the
following instructions carefully:

Instructions

 The radio operates with cathode-grounded power supply of
13.6V ± 15% only. Please check polarity and voltage of the
power supply on the vehicle before you install the radio.
 Please check how long the screws will extend from the bot-
tom surface of the radio, before you install the radio. Drill the
mounting hole cautiously to avoid damage to the vehicle wiring
and other parts.
 Please connect Hytera supplied antenna and power cord to
the radio, before you install it in the bracket. And make sure
the antenna and power cord is dedicated for Hytera digital
radios.
 Install the radio with Hytera supplied mounting bracket, to
avoid radio looseness in case of accidents. The loose radio
may cause bodily injury.
 Install the radio in a location where it's easy to reach the front
panel controls.
 Please make sure there's sufficient space at back of the radio
for wiring.
 When the fuse for DC power cord needs replacement, it must
be replaced by a fuse with the same specification.

Installation Tools

 Electric drill
 Cross head screwdriver
 Hex socket sleeve (used for 4.8*20mm self-tapping screws)
5