Changing The Presser Foot; Presser Foot Pressure; Presser Foot Lever - Husqvarna Platinum 730 User Manual

u roll,
I'Ia!,,un, O
Edging FootJ
—
This toot is used for overcasting, seam I
and overcasting, i.e. stitches which have
a stitch width of 5.0 and 5 mm. Stitches
I
t
Lf
form over the pin which prevents puck-
ering at the edge of the fabric.
LJ
Sensor Buttonhole Foot
When connected to the machine it gives
a
butk)nhole
length fitting the button
size that has been entered into the
machine. The middle mark gives a 9/16
(IS mm) buttoning edge.
Read
more
about di erent optional
pres.cer/et in the Accessory [er Guide.
Changing the Presser Foot
I Make sure that the needle is in the
—
highest position. Pull the presser
foot towards you.
2
Line up the cross pin
Ofl
the foot
with the gap in the presser foot
ankle. Press back until the foot
snaps into place.
Presser Foot Pressure (a)
The presser foot pressure is adjusted
with the dial found under the lid on your
Platinum 30. Normal setting is around
four. The higher the number the more
pressure the foot puts on the fabric.
Knit and soft fabrics should be sewn at
lower pressure.
Presser Foot Lever (b)
The presser foot is raised and lowered
with the presser foot lever. The presser
toot must be lowered when sewing.
By raising the presser foot lever and
then press it upwards, the lift height of
the presser foot can be raised to extra
height in order to slide thick projects
under the foot.
2