Cleaning; Replacing The Stitch Plate - Husqvarna Platinum 730 User Manual

Care of the Machine
To keep your sewing machine operat
ing well, clean
it
often. No lubrication
(oiling) is needed.
Cleaning
Wipe the exterior surfaces of your Plati
num 730 with a soft cloth to remove
any dust or lint built up.
Clean the Bobbin Area
Remove the presser foot and slide off
the bobbin cover. Lower the feed teeth.
Place the stitch plate opener on the
brush, and then in the recess at the rear
of the stitch plate. Turn toward you to
pop off the stitch plate. Clean the feed
teeth with the brush.
Cleaning Under the Bobbin Area
When lint builds up, the area under the
bobbin case must be cleaned.
Remove the bobbin case holder (1) cov
ering the front part of the bobbin case
(2). Remove the bobbin case by lifting it
up.
Clean with the brush.
Replace the bobbin case and the bobbin
case holder.
Replacing the Stitch Plate
With feed teeth down, place the stitch
plate about 5 mm in front of the rear
edge and push it hack. Slide on the
bobbin cover. Raise the feed teeth.
( a v,u, I'Ialjnu,n
(I
2
I--I