Lower The Feed Teeth; Presser Foot Pressure; Raise And Lower The Presser Foot; Changing The Presser Foot - Husqvarna Viking Tribute 145C User Manual

LOWER THE FEED TEETH

The feed teeth are lowered when you move the switch on the
front of the free arm to the right. Move the switch to the left
if you wish to raise the feed teeth. The feed teeth will raise
as you begin to sew. The feed teeth should be lowered when
sewing on buttons and for free motion sewing.

PRESSER FOOT PRESSURE

Normal presser foot pressure is around five. The higher the
number the more pressure the foot puts on the fabric. Knit
and soft fabrics should be sewn at lower pressure.
The presser foot pressure is adjusted with the dial found under
the lid. When adjusting the pressure lower the presser foot
first.

RAISE AND LOWER THE PRESSER FOOT

The presser foot is raised and lowered with the presser foot
lever (A). The presser foot must be lowered when sewing.
By raising the presser foot lever and then pressing it farther
upwards, the lift height of the presser foot is increased to an
extra height allowing you to slide very thick projects under the
foot.

CHANGING THE PRESSER FOOT

Press the ON/OFF switch to OFF.
1. Make sure the needle is in the highest position and the
presser foot is lifted. Pull the presser foot towards you.
2. Line up the cross pin on the foot with the gap in the
presser foot ankle. Push back until the foot snaps into
place.
A
GETTING READY TO SEW – 9