Belrobotics ParcMow Instruction Manual page 25

Situation
The robot remains at
the station for a long
5 time and does not
move away.
Alarm message on
screen:
6
"No wire signal"
B E L R O B
B E L R O B
Explanation
Screen displays: SC
(see §7.C, p.15)
The grass in the mowing area has
1
been adequately cut. The robot is
now resting at the station to save
energy and avoid damaging the
ground unnecessarily.
Screen displays: WU
(see §7.C, p.15)
2
The robot has been manually
brought to the charging station by a
user and won't start working again.
Screen displays: WT
(see §7.C, p.15)
3
The robot is resting during a
programmed rest period.
Screen displays: W.BH or W.FT
(see §7.C, p.15)
The robot is not working as its
4
battery temperature is too high or
too low. This helps to avoid damage
to the batteries or the land being
maintained.
5 Option O02: "Stay@Chge" has been
selected.
The LED at the back of the station is
not switched on.
1
The station is not connected to a
power supply.
The LED at the back of the station is
flashing red.
2
The boundary wire has been cut or
damaged.
The LED at the back of the station is
flashing green.
3
The problem could be coming from
the robot or from the ground.
O T I C S
O T I C S
This situation is normal.
The robot will continue its
work cycle again when
necessary.
If you want the robot to
switch on automatically
after a manual charge,
please press
This situation is normal.
The robot will continue its
work cycle again when
necessary.
This situation is normal.
The robot will continue its
work cycle again when
necessary.
To restart the robot, press
.
Check the status of the
electricity supply to the
station. If the LED still does
not light up, contact your
dealer.
Contact your dealer.
Contact your dealer.
Solution
.
25