Kenwood DNX5120 Instruction Manual page 104

Connection
Ignition key
switch
/f..
If you connect the ignition wire (red) and the battery
Loll
wire (yellow) to the car chassis (ground), you may
cause a short circuit, that in turn may start a fire. Always
connect those wires to the power source running
through the fuse box.
ACC
A
8
Ignition wire (Red)
A"'======~
Car fuse box
Car fuse box
(Main fuse)
Battery wire (Yellow)
8"'=====91
Ground wire (Black)
e
C ...
(To car chassis)
Antenna Cord
( I
==+,..
1>=
~
Connect to the vehicle's parking brake
~ detection switch harness.
Parking sensor wire (Light Green)
Reveres sensor wire (PurplelWhite)
Steering remote control input
(Light BluelYellow)
To steering remote
€B:P==================
To use the steering wheel remote control feature, you need to an
exclusive remote adapter (not supplied) matches your car is required.
When this terminal is not in use, leave its cap on.
~
~
For the sake of safety, be sure to connect the parking sensor.
' - - _ - J
Connect to vehicle's reverse lamp harness when
using the optional rear view camera.
...
To car light control switch
Dimmer control wire (OrangelWhite)
: Mute wire (Brown)
Connect to the terminal that is grounded when either:
the telephone rings or during conversation.:
=!===================
~
To connect the Kenwood navigation system,
~ consult your navigation manual.
Depending on what antenna you are using,:
~
Motor antenna control wire (Blue)
connect either to the control terminal of the motor antenna, or to the :
===================
power terminal for the booster amplifier of the film-type antenna. :
When using the optional power amplifier, : Power control wire (BluelWhite)
connect to its power control terminal. ...
~
If no connections are made, do not let the cable come out from the tab.
4
I
DDXS12/DDXS032