Step 3: 3G Status Con Rmation - Cisco AT&T 3G MicroCell Getting Started Manual

Step 3: 3G Status Con rmation

1. Make sure the Power
indicator will be solid green
Wait 90 minutes.
complete system con guration and 3G service activation. Do not turn o power or disconnect.
Note: The
*
If the Power or Ethernet status indicators are not solid green, see the Troubleshooting section on page 14 in the
MicroCell™ User Manual
2. After 90 minutes, look at your 3G MicroCell front panel status indicators.
3G Status Indicator Still Flashing after 90 Minutes?
Try these steps in this order:
1. Con rm that at least
2. Power cycle your 3G MicroCell. (Unplug the power adapter from the wall outlet, wait 10 seconds, then plug it back in.)
Wait 30 minutes for 3G indicator to go
3. If power cycling doesn't resolve the problem, see
alternative cabling con guration that may provide a solution.
4. If your 3G status indicator still
MicroCell™ User Manual
6
and Ethernet status indicators are
or ashing green during data transfer.
You have completed your part. Relax and give your 3G MicroCell time to
GPS and 3G status indicators will start
for more information.
3G Status Con rmation
*
Power
Solid Green
*
Ethernet
Solid Green
A
GPS
Solid Green
A
Computer
Option A: O
Option B: Solid Green or Flashing Green (during Data Transfer)
3G
Solid Green
90 minutes have passed since rst powering up the 3G MicroCell.
solid green
fails to go solid green, see the
, or contact AT&T Customer Support at
solid green *. If you chose Option B, the
ashing green within 10 minutes
.
Option C on page 11 in the
Troubleshooting section on page 14 in the
1.800.768.1212
Computer
.
• If the 3G status indicator is
3G activation is complete. You may
advance to Step 4: Final Con rmation
• If the 3G status indicator is
after 90 minutes , refer to the steps
below for solutions to try.
AT&T 3G MicroCell™ User Manual
for assistance.
status
AT&T 3G
solid green ,
.
still ashing
for an
AT&T 3G