Table of Contents
Advertisement
25. LINE V
ØA=120.0
ØB=120.0
ØC=120.0
26. LINE F
60.0 Hz
27. REM TEMP
+91°F
+33°C
28. CTL TEMP
+91°F
+33°C
29. RTIME
RTIME SS
HHHHH:MM
30. HARD-KEY
HARD-KEY
HARD KEY
XXXXXXXX
DISABLED
DISABLED
ENABLED
XXXXXXXX
XXXXXXXX
XXXXXXXX
XXXXXXXX
XXXXXXXX
26
View the RMS line voltage for each power phase.
Press EXECUTE to enter the menu and view the line voltage of each phase.
Shows the line voltage of Phase A.
Press MENU (
) to view the line voltage of Phase B.
Press MENU (
) to view the line voltage of Phase C.
Press ESCAPE or RESET to exit the menu.
View the line frequency of phase A.
Shows the frequency of phase A.
View the temperature of the remote temperature sensor.
Displays the temperature of the heat sink inside the J-PACK Series dimmer pack.
Shows the temperature in degrees Fahrenheit.
Press EXECUTE to toggle units between degrees Fahrenheit and Celsius.
View the temperature of the microcontroller.
Shows the temperature in degrees Fahrenheit.
Press EXECUTE to toggle units between degrees Fahrenheit and Celsius.
View the total run time of the microcontroller.
The run time counter keeps track of the total time the microcontroller is powered up.
The maximum time is 99999 hours, 59 minutes, 59 seconds, or about 11.4 years.
System operation is not effected when the maximum run time is reached and can be
reset to zero at the factory.
Shows the number of seconds (SS) of run time.
Shows the number of hours (HHHHH) and minutes (MM) of run time.
View the microcontroller's unique eight-character hard-key code.
J-PACK Series dimmer packs may be shipped with an invalid hard-key code of
00000000. A valid hard-key must be entered before the run time (RTIME) counter
reaches 2160 hours / 90 days. If the run time expires without a valid hard-key the
LCD display will show a runtime counter error (RTC ERR!) and all dimmer control
outputs will be disabled. This feature can help to ensure full and timely payments for
product distributors.
A dash (-) between HARD and KEY represents a valid hard-key.
A blank space between HARD and KEY represents an invalid hard-key.
Shows the unique eight-character hard-key code (XXXXXXXX).
This menu is disabled to help prevent inadvertent changes.
Follow the procedure below to enable the menu and modify the hard-key.
Press and hold MENU (
) and MENU (
The cursor ( ) indicates the hard-key character being modified.
Press MENU (
) to modify the hard-key character.
Press EXECUTE to advance within the menu, to the next hard-key character.
Press ESCAPE to back up within the menu, to the previous hard-key character.
Repeat until all characters are modified to the desired (valid) hard-key code.
Press ESCAPE to exit the menu and save the desired hard-key code.
Press RESET to exit the menu without saving.
The menu will automatically timeout after 2 minutes of inactivity and save.
NOTE: Be sure to record and file the hard-key code on page 28 for future reference.
WWW.JOHNSONSYSTEMS.COM
) at the same time for 4-5 seconds.
Advertisement
Table of Contents
