JOHNSON SYSTEMS J-PACK Series User Manual page 19

Advanced Menus
SCENESET Enable and setup 6 different backup scenes.
3.
When scene mode (SCENESET) is activated the selected scene will be held with no
timeout until the menu is exited. The 6 control channel levels are configured within
the menu and can be modified on the fly. Scene mode is useful when an external
controller is not available and independent internal control is required.
Press EXECUTE to enter the menu and activate scene mode.
SCENE>01 Displays the scene (01) to be activated.
SCENE>06 Press MENU (
CTRL: ON Control (CTRL) is ON via the selected scene.
CTRL:DMX Control (CTRL) is via DMX and takes priority over scene mode.
CTRL:HLD Control (CTRL) is via DMX status hold (HLD) and takes priority over scene mode.
CTRL:INF Control (CTRL) is via DMX status hold (INF) and takes priority over scene mode.
SCENE>06 Press EXECUTE to activate the selected scene.
SCENE:06 The colon (:) flashes twice per second while fading to the selected scene.
SCENE:06 The colon (:) stops flashing when fade is complete and the selected scene is active.
SCENE>06 Press MENU (
SCENE 06 Press EXECUTE to modify the selected scene.
C>01L 00 The second line on the LCD indicates the control channel (C) and level (L).
C>06L 00 Press MENU (
C 06L>00 Press EXECUTE to toggle from channel (C>) to level (L>) selection.
C>06L 00 Press ESCAPE to toggle from level (L>) to channel (C>) selection.
C 06L>FF Press MENU (
CLEAR??? Press EXECUTE to clear the selected preset, and set all channels to 00 level.
SURE ??? Press EXECUTE if you are sure to clear the selected preset.
DONE !!! Indicates the selected preset has been cleared.
WAIT... Press ESCAPE to exit and the menu and save programmed scene levels.
Press ESCAPE to back-up within the menu, or exit/deactivate scene mode.
Press RESET to exit scene mode without saving programmed scene levels.
NOTE: When scene mode is activated, DMX and DMX status hold (SH-TIME)
automatically takes precedence over scene mode.
4. FADETIME Set the fade time for each of the 6 scenes from 0 to 99 seconds.
The factory default is 5 seconds for all 6 scenes.
Press EXECUTE to enter the menu.
S>01T 05 Displays the scene (S>01) and assigned fade time (T 05).
S>06T 05 Press MENU (
S 06T>05 Press EXECUTE to toggle between scene (S>) and fade time (T>) selection.
S 06T>99 Press MENU (
Press ESCAPE to exit the menu and save the selected fade time.
Press RESET to exit the menu without saving.
The menu will automatically timeout after 2 minutes of inactivity and save.
WWW.JOHNSONSYSTEMS.COM
) to select a different scene from 01 to 06.
) to select a different scene from 01 to 06.
) to select the control channel (C) to modify from 01 to 06.
) to select the output level (L) for the selected channel from 00 to FF.
) to select a different scene from 01 to 06.
) to select a different fade time from 00 to 99 seconds.
19