Using The Hob; Fitting The Pan Stands - Smeg PX 140 A Instruction Manual

Built-in hob

Table of Contents

Instructions for the User

Using the hob

Check that the burners, flame diffuser rings and

pan stands are fitted correctly.

The projections A on the flame diffuser rings must

be fitted into the recesses B in the burner. The

holes C in the burner must mate with the ignition

plugs and thermocouples D on the hob.

The pan stands are supplied dismantled from the hob. To place each pan stand on its

burner correctly, follow the instructions provided below:

At the ends of the legs of the pan stands there

are silicone gaiters with a hole that must be

centred onto the matching fixing pins on the

hob.

Each pan stand must be positioned on the

corresponding burner in order to guarantee

proper operation.

Be very careful to match the different central

diameters of the pan stands to the flame-

spreader crowns.

To position the pan stand, you

first need to centre the fixing

pins (1) and (2) and then lower

it until it is resting on the hob.

When properly positioned, the

legs of the pan stands must not

hang above the hob but should

rest on top of it.

Table of Contents