Removing And Replacing The Spacer Gasket - Motorola V series 60g Service Manual
Tri-band digital wireless telephone gsm 900/1800/1900 mhz & gprs technologies
Hide thumbs
Also See for V series 60g:
- User manual (222 pages) ,
- Start here manual (94 pages) ,
- User manual (222 pages)
Table of Contents
Advertisement
Disassembly
Removing and Replacing the Spacer Gasket
28
1.
Remove battery housing, battery, antenna, rear chassis assembly, and trans-
ceiver board assembly as described in the procedures.
2.
Using the disassembly tool, lift the spacer gasket completely from the keyboard
assembly. See Figure 15.
KEYBOARD ASSEMBLY
SPACER GASKET
FRONT HOUSING
Figure 15. Removing the spacer gasket
3.
To replace, position the spacer gasket so the alignment pins on the spacer
gasket line up with the alignment holes on the keyboard assembly. Press the
spacer gasket into place, ensuring it is flat against the keyboard assembly.
4.
Replace the transceiver board assembly, rear chassis assembly, antenna,
battery, and battery housing as described in the procedures.
V. Series 60g
DISASSEMBLY TOOL
010636o
6881038B35
Advertisement
Table of Contents
Troubleshooting
