Installation Instructions; Freestanding Outdoor Grill Installation - KitchenAid FREESTANDING OUTDOOR GRILL Installation Instructions And Use & Care Manual

Hardware contents pre-installed as noted in instructions
that follow.
REF#
1 1/4"*15MM Truss Head Screw
2 5/32"*10MM Truss Head Screw
3 3 5/32"*10MM Countersunk Head screw 5/32"*10MM Countersunk Head screw
4 1/4"*12MM Truss Head Screw
5 5/32" Flat Washer
1. 2.
Preparation
Before beginning assembly, make sure all parts are present.
Compare parts with package contents list and diagram
above. If any part is missing or damaged, do not attempt to
assemble the product. Contact customer service for
replacements parts.
• Estimated Assembly Time: 20 minutes
• Note: The right and left sides of the grill are designated as
if you are facing the front of the grill.
Swivel Caster Assembly
1. Unpack bottom panel and 4 casters. Remove 16
screws pre-assembled on the bottom panel and use
those screws to secure the four casters. Two casters
(H) should assemble on the line of left side, swivel
caster (I) assemble on the front right side, swivel caster
with brake (J) assemble on the rear right side as shown
below.

INSTALLATION INSTRUCTIONS

Freestanding Outdoor Grill Installation

Description
3. 4.
J
QTY
16pcs
2. Loosen screw and washer which is attached to tank
bolt from outside of gas tank tray (T). Remove tank
13pcs
bolt from inside and insert the bolt from outside of
tank tray. Re-attach screw and washer from inside
12pcs 12pcs
the tank tray.
10pcs
2pcs
5.
Attach the L shape bracket with the bottom panel
1. Loose 2 screws which are pre-assembled to the
left side of the bottom panel.
2. Secure the L shape bracket by clipping the open
hole onto the screws and tighten 2 screws.
Cart Assembly
1. Unpack the left side panel (B) , right side panel (C)
and rear panel (D). Loosen 8 screws which are pre-
assembled on the bottom panel and 6 pre- assembled on the bottom panel and 6 pre-
assembled screws on the left and right side panels.
2. Secure the left side panel (B) by clipping the open
hole onto the screws which are pre-assembled to
the bottom panel and tighten the 3 screws.
s
I
H
T
11