KitchenAid FREESTANDING OUTDOOR GRILL Installation Instructions And Use & Care Manual page 12

3. Secure the right side panel (C) by clipping the open hole
onto the screws which are pre-assembled to the bottom
panel and rear panel and tighten the remaining 8 screws.
4. Secure the rear panel (D) by clipping the open hole onto
the screws which are pre assembled to the bottom panel the screws which are pre-assembled to the bottom panel
and the left side panel. Tighten the 3 screws to the side
panel.
D
5. Secure the door supporting trim (S) by clipping the open
hole onto the screws which are pre-assembled to the
bottom panel and the right side panel. Tighten the 3
screws to the right side panel.
12
6.
C
7.
S
Place the cart frame (k) in position with notch facing
up and to the right. Remove the top screw and
loosen the bottom screw for the left and right side of
the frame. Remove the screws at the front of the
inside of the side panels. Align the notches in the side
panels with the screws in the cart frame. Screw the 2
top screws into the cart frame and the 2 screws into top screws into the cart frame and the 2 screws into
the inside of the side panels that were previously
removed. Tighten all 6 screws.
Remove 4 screws pre-assembled on the door (E) as
shown below.
Remove the top
screw and loosen
the bottom screw
K
Screw the top screw
and the screw
removed from inside
the side panel.
E