Installation Requirements; Tools And Parts; Location Requirements - KitchenAid FREESTANDING OUTDOOR GRILL Installation Instructions And Use & Care Manual

Tools and Parts

Gather these required tools and parts before starting
installation. Read and follow the instructions provided with
any tools listed here.
Tools Needed
 Phillips screwdriver
 Wrench or pliers
 Pipe wrench
Parts Supplied
 Gas pressure regulator/hose assembly set for 11"
WCP LP gas

Right side shelf

Left side shelf
 "AA" Battery (1)

Warming rack g

Cooking grids

Grease cup

Door hinges

Flame tamers

Natural gas orifice for rear burner
Parts Needed

20lb LP gas fuel tank-approximately 18"(45.7cm height)
and 12"(30.5cm) diameter
Parts Needed for Conversion to Natural Gas

Natural gas conversion kit Part Number 710-0003. See
"Assistance" section to order. The conversion kit includes:

N t Natural gas regulator 4" W.C. (marked "Natural Gas l l t
Regulator")

10 ft (3.0 m) Natural gas hose with quick connector

5.9" (150 mm) Natural gas regulator hose

6 mm nut driver

6 mm wrench

Hex key

Gas line shutoff valve G li h t ff l

1/2" male pipe thread nipple for connection to pressure
regulator.

LP gas-resistant pipe-joint compound

CSA design-certified outdoor flexible stainless steel
appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas
supply line as needed.

Installation Requirements

 Scissors or cutting pliers (to
remove tiedowns)
 Noncorrosive leak-detection
solution solution
4" W C ( k d "N t
Select a location that provides minimum exposure to
wind and traffic paths. The location should be away
l G
from strong draft areas.
Do not obstruct flow of combustion and ventilation air.
Clearance to combustible construction for grill:
 A minimum of 24" (61 cm) must be maintained
between the front of the grill hood, sides and back of
the grill and any combustible construction.
 A 24" (61 cm) minimum clearance must also be
maintained below the cooking surface and any
combustible construction.

Location Requirements

p y
5