Initial Settings For Refrigerant Leakage Detection Function - Mitsubishi Electric Mr.Slim PUHZ-RP35VHA2 Service Manual

13-3 INITIAL SETTINGS FOR REFRIGERANT LEAKAGE DETECTION FUNCTION

Remote controller button position
A
D
Compressor information Outdoor unit information Indoor unit information
Operation mode
[Display A ]
Refrigerant leakage
detection
(initial teaching)
GAS LEAK
TEST START
[Display D ] Waiting for stabilization
C B
This air conditioner (Outdoor unit) can detect refrigerant leakage
which may happen during a long period of use.In order to enable
the leakage detection, the following settings are required to let the
unit memorize the initial condition (initial refregerant amount).
Confirm
1.How to select the "Refrigerant Leakage Detection" mode
Refrigerant leakage
Detection is possible regardless the unit`s operation (ON or OFF).
detection judgement
1Press
GAS LEAK
JUDGE
2.How to start the initial learning
2Press
* The initial learning for the leakage detection is always done once after
After 45 minutes
3Press
How to finish the initial learning
Once the unit`s operation is stabilized, the initial learning is completed.
4'Press
The initial learning can also be cancelled by pressing
105
Caution :
Make sure to perform the "test run" and confirm the unit works
without any problems, before starting the following setting.
For more precise detection, make sure to set the airflow at
"High notch" before enable this setting.
button for more than three seconds to switch to
TEST
"EASY MAINTENANCE" mode.[Display A]
w
CLOCK button and select the [GAS LEAK TEST START]
the new installation or the data reset.
Stabilized
( )button to confirm.
FILTER
button for more than 3 seconds to cancel the initial leaning.
TEST
button.
1ON/OFF