B-300 HDMATRIX Installation and Users Manual 4X4 & 8X8
8.3 EDID STATUS
Once EDIDs are configured, the assigned EDID for sources can be reviewed to ensure that the desired output is
configured or for troubleshooting.
Example: Input=3
1. Press STATUS
2. Press INPUT
3. Press Number Key (1-8)to select the desired Input
4. Press ENTER
• If the second digit (the Input being queried) has a dot after it, then the first digit is the
EDID number from the Embedded EDID table.
• If the second digit (the Input being queried) does not have a dot after it, the first digit is
the output the EDID was learned from.
9 ADVANCED CONFIGURATION
During the installation of an HDMatrix, there are settings that provide Advanced Configuration beyond the use
of the remote. These allow for fine tuning the HDMatrix when used under certain conditions and the settings
listed below are not available from the remote.
For more information refer to the Configuration Utility manual available on the SnapAV website.
9.1 PC CONFIGURATION OTHER SETTINGS
The following settings can be found in the PC Configuration Utility Other Settings menu.
9.1.1 IR RECEIVER ACTIVE
Use this setting to disable the front panel IR receiver to avoid IR command conflicts and prevent IR flooding of
the HDMatrix. When IR is disabled, RS232 or IP must be used to control the HDMatrix.
9.1.2 FRONT PANEL POWER BUTTON ACTIVE
Use this feature to disable/Enable the front panel power button of the HDMatrix when using an Automation
This will prevent the HDMatrix from being powered OFF and preventing control of the device
System.
from an automation system UI.
9.1.3 HDMI INPUT EQ SETTING
Use these settings when an HDMI image contains video noise and artifacts that can occur during switching
or viewing some HDMI sources or displays. Each input can be set to High when video noise is present. We
recommend that this be set to LOW as a starting point, and only changed should video noise be present on a
particular input.
pg.16
Display Readout (Example)
EDID 5 Assigned
EDID Learned
from Embedded
from Output 4
EDID Table
--
--
-3
5
3
.
.
--
--
-3
4
3
.