Deleting All Settings - Omron Walking styleX Instruction Manual

10.1 Replacing the battery
1 Loosen the screw of the battery cover on
the back of the unit, and remove the
battery cover by pulling it off in the
direction of the arrow.
Use the supplied screwdriver or use a
small screwdriver to loosen the screw on
the battery cover.
2 Remove the battery with a thin, sturdy,
stick that will not break easily.
Note: Do not use a pair of metal tweezers or
a screwdriver.
3 Insert the battery (CR2032) with the
positive (+) side face up.
4 Replace the battery cover by
sliding the catch in first, then
tighten the screw.

11 Deleting all settings

Follow the procedure below to delete all the previous
measurement results and settings, including the time, weight,
height, and stride length.
1 Press the SET button on the back of the unit with
a thin, sturdy, stick that will not break easily.
Note: Do not press the button with a sharp point. This
could cause damage.
The hour setting will flash.
2 Press
2 seconds.
After "ALL Clr" has been displayed, the hour setting will
appear.
The measurement results stored in memory and the
settings for the time, weight, height, and stride length are
deleted. To continue using the unit, reset the time, weight,
height, and stride length settings (refer to Chapter 5
"Settings").
12
and at the same time for at least