Skoda Yeti Owner's Manual page 69

Remove variable loading floor
Fig. 61 Boot: Fold up variable loading floor/remove
Remove variable loading floor
›
Fold up the loading floor by moving it in the direction of the arrow
›
Fold up the variable loading floor in direction of arrow
›
Pull on both sides of the locking levers in direction of arrow
›
Remove the variable loading floor in direction of arrow
›
The variable loading floor is installed in the reverse order.
Secure the variable loading floor in the raised position
›
Fold up the hooks on the fastening strip in direction of arrow
page 64.
›
Fold up the variable loading floor behind the rear back backrests.
›
Fold down the hooks in direction of arrow
›
Support the variable loading floor on the hooks folded downwards.
» Fig. 61.
1
.
2
.
3
.
4
» Fig. 57 on
1
as far as the stop.
3
Removing and installing carrier rails
Fig. 62 Slacken check points/remove carrier rails
Removing
›
Slacken the check points
B
or a flat screwdriver.
›
Grasp the carrier rail at position
A
of arrow.
›
Grasp the carrier rail at position
A
of arrow.
Install
›
Position the carrier rails on the sides of the boot.
›
Press both check points on each carrier rail
›
Check the attachment of the carrier rails by pulling it.
Ð
WARNING
Pay attention when installing the variable loading floor that the carrier rails
and the variable loading floor are correctly fixed, otherwise the occupants are
at risk.
» Fig. 62 on the carrier rails using the vehicle key
and slacken it by pulling in the direction
1
and slacken it by pulling in the direction
2
up to the stop.
B
Seats and Stowage
Ð
67