Skoda Yeti Owner's Manual page 202

For tightening purposes, we recommend, for example, using the wheel wrench,
towing eye from another vehicle or a similar object that can be pushed through
the eye.
On vehicles with a factory-fitted towing device, there is no mount for the screw-
in towing eye behind the cap » page
CAUTION
The towing eye must always be screwed in fully and firmly tightened, otherwise
the towing eye can tear when towing in or tow-starting.
Vehicles a towing device
ä
First read and observe the introductory information and safety warn-
ings on page 198.
On vehicles with a factory-fitted towing device, there is no mount for the screw-
in towing eye behind the cap.
Use the detachable ball rod for towing purposes - for the installation of the de-
tachable ball rod, refer to the operating instructions for the towing device.
Towing the vehicle using the towing device is a viable alternative solution to us-
ing the towing eye.
If the towing device is removed completely, it must be replaced with the standard
reinforcement of the rear bumper which is part of the mount for the towing eye.
If this procedure is not observed, the vehicle may not meet the national legal pro-
visions.
CAUTION
The detachable ball rod and the vehicle can be damaged if an unsuitable tow bar
is used.
Note
The detachable ball rod must always be in the vehicle so that it can be used for
towing, if necessary.
200
Do-it-yourself
200, Vehicles a towing device.
Ð
Ð