Saw Chain Filing And File Gauges - Husqvarna 1153176-95 Operator's Manual

Recommended original and replacement bar and chain combinations
These Husqvarna chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply
with low kickback performance requirements. However, for these models we recommend the following cutting
equipment.
Bar
Length, inch Pitch, inch
18-28 3/8"
18-28 3/8"
Listed ATM is the Oregon designation of Armour Tip Medium hard nose bar.
Note: For the chains above you are free to choose between 0,050" and 0,058" gauge drive link for the corresponding
bar, see the table below.
0,050"/1,3 mm
0,058"/1,5 mm
WARNING! This chain saw model is capable of severe kickback that could result in serious injuries
!
to the user. Do not operate this saw unless you have extraordinary cutting needs and experience
and specialized training for dealing with kickback. Saws with significantly reduced kickback
potential are available. Always use the safest saw and cutting equipment applicable to your cutting
need.
Saw chain filing and file gauges
TECHNICAL DATA
Gauge, inch
0,058
0,058
- 72LP 72LG
H42 73LP 73LG
Chain
Max. nose radius Type
11T Husqvarna H42,
Oregon 73LP /
ATM 1,33"
73LG / 73V
72V
73V
Drive link count
68-92
68-92
English – 39