Saw Chain Filing And File Gauges - Husqvarna 357XP/XPG Operator's Manual

Recommended cutting equipment for Canada
The following is a list of recommended cutting equipment for chain saws Husqvarna 357 XP, 357 XPG, 357 XP E-tech,
357 XPG E-tech, 359, 359G, 359 E-tech and 359G E-tech. The combinations of powerhead, guide bar and saw chain
meet all requirements outlined in the CSA Z62.1-03 Chainsaws and Z62.3-04 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose guide bar having the same length and nose radius as a sprocket-nose guide bar may be considered to have
equivalent or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed guide bars and saw chains or "Type C Low-Kickback Saw Chains"
which are available at your dealer.
Length, inch Pitch, inch
13
15
16 0.325
18
20
13
15
16 0.325
18
20
15
16
18 3/8"
20
24
Note: For the saw chains above (if available) you are free to choose between 0.050" or 0.058" gauge drive links for the
corresponding bar, see the table below.
0,050" H30 H22
0.058" - H25
Saw chain filing and file gauges
Technical data
Guide bar
Gauge, inch Max. nose radius
0.050 10T
10T
0.058
12T
0.058 11T
Saw chain
Type Drive link count
56
64
Husqvarna H30 66
72
78
56
64
Husqvarna H25 66
72
78
56
60
Husqvarna H42 68
72
84
English – 41