Lubricating The Bar Tip Sprocket; Needle Bearing Lubrication; Adjustment Of The Oil Pump; Cooling System - Husqvarna 1153176-95 Operator's Manual

before taking any further action. If the spark plug is dirty,
clean it and check that the electrode gap is 0.020 inch (0.5
mm). The spark plug should be replaced after about a
month in operation or earlier if necessary.
Note! Always use the recommended spark plug type! Use
of the wrong spark plug can damage the piston/cylinder.
Check that the spark plug is fitted with a suppressor.

Lubricating the bar tip sprocket

Lubricate the bar tip sprocket each time you refuel. Use
the special grease gun and a good quality bearing grease.

Needle bearing lubrication

The clutch drum has a needle bearing on the output shaft.
This needle bearing must be lubricated regularly (once a
week). When lubricating, remove the clutch cover by
loosening the two bar nuts. Lay the saw on its side with
the clutch drum upwards.
Lubrication involves engine oil dripping into the centre of
the clutch drum as it rotates.
MAINTENANCE

Adjustment of the oil pump

The oil pump is adjustable. Adjustments are made by
turning the screw using a screwdriver or combination
spanner. The machine is supplied from the factory with
the screw set to position 2. Turning the screw clockwise
will reduce the oil flow and turning the screw anti-
clockwise will increase the oil flow.
2
3
Recommended settings:
Bar 18"-20":
Bar 22"-26":
Bar 28" - :
!

Cooling system

To keep the working temperature as low as possible the
machine is equipped with a cooling system.
The cooling system consists of:
1 Air intake on the starter.
2 Air guide plate.
3 Fins on the flywheel.
4 Cooling fins on the cylinder.
5 Cylinder cover (directs cold air over the cylinder).
3
+
–
1
Position 1
Position 2
Position 3
WARNING! The engine must be stopped
when making adjustments.
5
4
2
1
–
English 35