Lighting Instructions; Important Information; For Your Safety - Jandy LG125 Installation And Operation Manual

Model LG Pool and Spa Heater
FOR YOUR SAFETY READ
BEFORE OPERATING
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result, causing
property damage, personal injury or loss of life.

LIGHTING INSTRUCTIONS

INSTRUCTIONS TO LIGHT HEATER
1. Position ON/OFF switch to "OFF".
2. Turn gas control knob clockwise
"OFF" position.
3. Wait five (5) minutes before lighting pilot.
4. Turn knob on gas valve counterclockwise
"PILOT" then push control knob all the way and hold
down. Push the button of the sparker, repeating until
confirming that pilot lights, by observing reflection on
burner tray mirror. Continue to hold the control knob in
for about one (1) minute after the pilot is lit. If it goes
out, repeat steps 3 and 4.
5. Turn gas control knob counterclockwise
6. After replacing door, set thermostat to desired setting
and turn appliance ON/OFF switch to "ON". Valve has
built-in delay before coming on.
RELIGHTING
If pilot goes out, repeat steps 1 through 6.
TO SHUT OFF HEATER
To shut off main burners turn gas control knob
clockwise until it stops at "PILOT". For complete
shut-off press down slightly on knob while turning
clockwise to "OFF". Do not force.
Position ON/OFF switch to "OFF".
DIRECTION
OF FLOW

IMPORTANT INFORMATION

1. CAUTION: Do not store pool chemicals or flammable
materials near this appliance.
2. PH LEVEL: Pool Water must be maintained between 7.4
and 7.6 when operating unit (See section entitled "Water
Chemistry" in operating manual).
3. BACKWASHING: Turn heater off 20 minutes before
backwashing or shutting down filter to prevent damage to
unit.
4. WINTERIZE: All gas to unit must be shut off and all water
drained from unit to protect it from freezing damage.
NOTE: THIS DOOR MUST BE FITTED TO UNIT DURING
NORMAL OPERATIONS.

FOR YOUR SAFETY

DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE
VAPORS OR LIQUIDS IN THE VICINITY OF THIS OR ANY
OTHER APPLIANCE.
NOTE: SOME EXPOSED PARTS OF THIS HEATER MAY BE
HOT WHEN OPERATING.
until it stops at
to
to "ON".
PILOT
BURNER
TO VALVE
Page 21