Operation - Piranha CZ-901 User Manual

8

Operation

Note: Ensure the Micro Fibre Pad is fitted before use.
• After fitting the Micro Fibre Pad, lay the steam mop down on its back.
• Remove the water tank by sliding it towards the handle then lift up.
• Fill the water tank to the "Max" mark then refit the cap securely.
• Refit the water tank by locating it in the Steam Cleaner body and then
slide down all the way until fully inserted.
• Ensuring the power cord is fully unwound, insert the plug into the power
point and switch on. The Indicator light on the front face of the Steam
Cleaner Body will illuminate.
• Stand the Steam Mop Up so it is standing on the floor head.
• Pull the trigger on the Handle to start the pump and the heating.
Note: The Red indicator light will illuminate and remain On while power is
supplied to the Steam Mop.
• After approximately 15 – 30 seconds (depending on the initial water
temperature) steam will begin to jet out from the base of the Steam Mop
and into the Micro Fibre Pad.
Note: A small amount of water may initially be ejected from the base
when heating starts.
Page 8 of 12