Operation - Piranha JJB-603 User Manual

8

Operation

• After fitting the Micro Fibre Pad, place the steam mop on the rubber mat
supplied.
Note: Ensure the Micro Fibre Pad is fitted before use.
• Unscrew the Water Fill Cap and remove.
• Using the 250ml beaker supplied, pour 250ml of clean water into the
water tank then refit the cap and tighten securely.
Note: do not use more that 250ml of water at any time as hot water (not
steam) will be ejected through the steam nozzles and may cause injury or
damage.
Always use up the water in the tank before refilling, or, empty the
remainder of the water out first, then refill.
• Ensuring the power cord is fully unwound, insert the plug into the power
point and switch on.
• Press the On / Off switch (on the back of the Steam Mop) with your foot to
turn the steam mop On.
• The Red and Green indicator lights will illuminate.
Note: The Red indicator light will illuminate and remain On while power is
supplied to the Steam Mop.
The Green indicator light will illuminate when power is supplied to the
Steam Mop, the On / Off switch is in the ON position, and the water in the
tank is heating up.
• After approximately 2 – 3 minutes (depending on the initial water
temperature) steam will begin to jet out from the base of the Steam Mop
and into the Micro Fibre Pad.
Note: A small amount of water may initially be ejected from the base
when the steam valve opens.
Page 7 of 10