Circuit Breakers; Joystick Assembly; Enhanced Display; Motor Locks - Quickie Xplore Owner's Manual

C. CIRCUIT BREAKERS
Your Quickie Xplore has a single circuit breaker.
• In the unlikely event of a short circuit or heavy overload, all
power to your chair will be shut off.
• To reset your chair, depress the circuit breaker button (a).
The circuit breaker will reset after a few minutes.
To access the circuit breaker
•
Push the battery box panel while pulling the handle.
•
Drop the panel down and the circuit breaker becomes
visible (a).
•
Reset the circuit breaker.
•
Lock the panel back into the upright position.
Repeated Shutdown:
If the chair continues to shut down after resetting, have it
serviced by a supplier.
D. JOYSTICK ASSEMBLY
The joystick connects to a controller, which controls the
chair's performance. The joystick varies based on the option
selected for you.
1. VR2 Joystick *
2. R-Net (Option)*
*Please refer to the user's manual provided with the infor-
mation package.
E. ENHANCED DISPLAY
Please refer to the P & G Enhanced Display owner's manual.
F. MOTOR LOCKS
Disconnect the motor locks when you need to manually push
the chair. (For example, in an emergency, or if batteries fail).
WARNING
. Do not disengage motor locks unless power to the chair is
1
off.
2. Be aware that the chair will not have brakes in the free-
wheel position.
3. Make sure that the person pushing the chair has full control
when motor locks are disengaged.
1. To Disengage Motor Locks:
Pull the lever (b) out and towards the wheel to disengage the
motor lock.
2. To Engage Motor Locks:
Push the lever in to return to the drive position.
Q-NOTE- If the lever is difficult to disengage, rock the
wheelchair slightly from front to rear and/or push against the chair
while moving the lever.
Quickie Xplore Owner's Manual
a
VR2
b
Rev. B
R-Net
18.