Operating Guide; Performance Control Settings; On Board Programmer Or Dtt; Or Rnet Pc Programmer - Quickie Pulse Owner's Manual

Q U I C K I E P U L S E
A. PERFORMANCE CONTROL SETTINGS
NOTE– Seek advice regarding checking and adjusting settings.
1. It is vital to match control settings to your level of function and ability.
2. Consult your health care professional and your supplier to select the best control set-
tings for you.
3. Check and adjust the settings every six to twelve months.
Adjust the control settings immediately if you notice any change in your ability
to:
• Control the joystick.
• Avoid running into objects.
4. Control Settings can be adjusted by your dealer.
B. ON BOARD PROGRAMMER OR DTT (DIAGNOSTIC TEST
TOOL) OR RNET PC PROGRAMMER
Program settings beyond the ability of the user can result in serious injury.
Consult your health care advisor before you alter settings.
The On-board Programmer or RNET PC Programmer lets you adjust the control settings of
the Pulse. Listed below are a few of the many settings that can be adjust via the On-board
Programmer or RNET PC Programmer. (See RNET OBP Owners Manual for full program-
mable parameters.)
• acceleration rate
• deceleration rate
• turn acceleration
• turn deceleration
• forward speed (max & min)
• reverse speed (max & min)
• turn speed (max & min)
• steer correct
Programming the Chair:
a. Access OBP or DTT/PC Programming by using Dongle connected inline of communi-
cation cable.
b. Program as needed.
c. Remove Dongle or recycle power.
NOTE– Review the RNET OBP Owner's Manual for more details on how to program your chair.
C. THERMAL ROLL-BACK
Your chair has a thermal roll back circuit. This protects the controller from damage due to
overheating. In extreme conditions (such as repetitive hill climbing) the circuit will decrease the
power to your motors. This allows the chair to operate at a reduced speed. When the con-
troller cools, the chair will return to normal speed.
D. CIRCUIT BREAKERS
1. Notes:
Your Quickie Pulse has a circuit breaker at the front of the chair.
• In the unlikely event of a short circuit or heavy overload, all power to your chair will be
shut off.
• To reset your chair, depress the circuit breaker button located at the rear corner of the
chair. A few minutes wait is required before the circuit breaker will reset.
2. Repeated Shutdown:
If the chair continues to shut down after resetting, have it serviced by a supplier.
103688 Rev. A
IX. OPERATING GUIDE
WARNING
(Optional)
WARNING
18
I X . O P E R AT I N G G U I D E
Circuit
Breaker