Service Checklist-Diagnosis Guide - Spirit XT285 1611285 Owner's Manual

SERVICE CHECKLIST - DIAGNOSIS GUIDE
'E CHECKLIST - DIAGNOSIS GUIDE
Before contacting your dealer for aid, please review the following information. It may
save you both time and expense. This list includes common problems that may not be
covered under the treadmill's warranty.
PROBLEM
Display does not light
Tread-belt does not stay centered
Treadmill belt hesitates when
walked/run on
Motor is not responsive after
pressing start
Treadmill will only achieve
approximately 12 kmph (7 mph)
but shows higher speed on
display
Tread-belt stops quickly/suddenly
when tether cord is pulled
Treadmill trips on board 15 amp circuit
Computer shuts off when console is
touched (on a cold day) while
walking/running
House circuit breaker trips, but not
the treadmill circuit breaker
CUSTOMER SERVICE 1-888-707-1880
SOLUTION/CAUSE
1. Tether cord not in position.
2. Circuit breaker on front grill tripped. Push circuit
breaker in until it locks.
3. Plug is disconnected. Make sure plug is firmly
pushed into AC household wall outlet.
4. Household circuit breaker may be tripped.
5. Treadmill defect. Contact your dealer.
The user may be walking while favoring or putting
more weight on either the left or right foot. If this
walking pattern is natural, track the belt slightly off-
center to the side opposite from the belt
movement. See General Maintenance section on
Tread-belt Tension. Adjust as necessary.
1. If the belt moves, but stops after a short time
and the display shows "LS", run calibration.
2. If you press start and the belt never moves,
then the display shows LS, contact service.
This indicates motor should be receiving power to
operate. Low AC voltage to treadmill. Do not use
an extension cord. If an extension cord is required
it should be as short as possible and heavy duty
16 gauge minimum. Low household voltage.
Contact an electrician or your dealer. A
minimum of 230 volt AC current is required.
High belt/deck friction. See General Maintenance
section on lubrication.
High belt/deck friction. See General Maintenance
Treadmill may not be grounded. Static electricity is
"crashing" the computer. Refer to Grounding
Instructions on page 3.
Need to replace the house breaker with a "High In-
rush current" type breaker (see page 3 for details)
31 MAURICE PINCOFFS CANADA©2011