Preparing The Hardware - TracPhone User Manual

IP Handset connectors
The handset has two connectors on the side of the handset:
• one connector for connecting a headset.
• one Mini-USB 5-pin connector, for charging the handset from a computer
or USB charger.
Mini-USB for charging

Preparing the hardware

For the wireless IP Handset you need the following hardware:
• A BGAN terminal with integrated wireless access point or a separate
wireless access point complying to the Wireless Local Area Networking
(WLAN) standard 802.11b/g
• for charging the handset:
• an external power supply with 10-32 V DC nominal power, min. 7 W, or
• a computer and a USB cable with a mini-USB 5-pin connector at one
end and a USB-A connector at the other end.
To connect the wireless access point
If the BGAN terminal has not an integrated wireless access point you may
connect the wireless access point to a BGAN terminal or to your standard
network connection.
For information on how to install the wireless access point, refer to the
documentation that comes with your wireless access point.
Getting started with the wireless IP Handset
Chapter 2: Getting started
Jack connector for headset
15