NEC N8100-1447F User Manual page 83

Server
The Server menu appears if you move the cursor to "Server".
See the table below for the items.
Option
Assert NMI on
SERR
Post Error Pause
AC LINK
The table below shows the operation when the AC power to the server is turn off once and then on
again, depending on the setting of "AC LINK".
System status before AC power off
Operating
Aborting (DC power being off also)
Forced shutdown*
* Press the power switch continuously for four seconds or longer. This forcibly turns off the power.
IMPORTANT:
To power on the server from the UPS (Uninterruptible Power
Supply), select [Server] - [AC Link] - [Power On].
If the server is connected to the UPS, set at least 10 seconds delay in
the power-on schedule.
Parameter Description
Disabled Indicates whether PCI SERR is
[Enabled] supported or not.
Disabled Indicates whether POST is aborted once
[Enabled] at the end of POST if an error occurs
during the execution of POST.
Stay Off Specify the state of power when the AC
[Last State] power to the server is turned off once
Power On and then on. (See the table below.)
Configuring Your Server 4-23
Setting of AC LINK
Stay Off Last State
Off On
Off Off
Off Off
Your Setting
[ ]: Factory-set
Power On
On
On
On