NEC N8100-1447F User Manual page 284

D-8 Installing Windows Server 2003 x64 Editions
8.
Select the proper SCSI Adapter and press Enter.
– [LSI MegaRAID SAS RAID Controller Driver (Server 2003 for x64)]
(When N8103-117 board is installed.)
– [LSI MegaRAID SAS RAID Controller Driver (Server 2003 for x64)]
(When N8103-116 board is installed.)
– [LSI Embedded MegaRAID (Windows XP/2003 64-bit)]
(When LSI Embedded MegaRAID is used.)
9.
If you utilize N8103-75/107, select the [Adaptec Ultra320 SCSI Cards (Windows 64-bit)]
and press Enter.
IMPORTANT:
the message below is shown.
The driver you provided seems to be newer than the Windows
default driver.
Windows already has a driver that you can use for "Adaptec
Ultra320 SCSI Cards (Windows 64-bit)".
Unless the device manufacturer prefers that you use the driver
on the floppy disk, you should use the driver in Windows.
Continue performing tasks according to the subsequent messages that appear.
10.
When the following message is shown, press Enter to start "Welcome to Setup".
IMPORTANT:
the hard disk larger than 2,097,152MB (2TB), you can specify only a
value equal to or less than 2,097,152MB as partition size.
11.
When the installation of Windows Server 2003 x64 Editions has finished, the system
reboots automatically.
If you utilize N8103-75/107, press S to proceed when
If you install Windows Server 2003 x64 Editions on