Cleaning Disc - NEC N8100-1447F User Manual

7-6 Maintenance

Cleaning Disc

A dusty disc or dust-accumulated tray causes the device to fail to read data correctly.
Follow the procedure below to clean the tray and disc regularly:
1.
Make sure that the server is powered (the POWER/SLEEP LED is lit).
2.
Press the CD tray Open/Close button on the front of the optical disk drive.
The tray opens.
3.
Hold the disc lightly and take it out from the tray.
NOTE:
4.
Wipe the tray with a dry soft cloth.
IMPORTANT:
so may damage the lens and may cause a malfunction of the drive.
5.
Push on the tray front to close the tray.
6.
Wipe the signal side of the disc with a dry soft cloth.
IMPORTANT:
cleaner if necessary. Cleaning a disc with record spray/cleaner, benzene,
or thinner causes damage to the disc contents. At worst, inserting the
disc into the server may cause failure.
Do not touch the signal side of the disc with your hand.
Do not wipe the lens of the optical disk drive. Doing
Wipe disc from the center to the outside. Use only disc