Section 6-Troubleshooting; Troubleshooting - Keurig K-Cup K10 MINI Plus Owner's Manual

Single cup brewer system
Hide thumbs Also See for K-Cup K10 MINI Plus:
Table of Contents

Advertisement

P16 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06
SeCtIon 6

Troubleshooting

Brewer does not have power
BReW Button flashes red too long
Add Water indicator does not flash blue
Brewer will not brew
SiTUATion
SoLUTion
• Make sure the Power Button has been pressed. The Add Water Indicator should flash blue
after pushing the Power Button. Note that the Power Button does not illuminate.
• During normal operation, the brewer will shut off when it is idle for longer than 90
seconds. Just press the Power Button to restart.
• Plug brewer into an independent outlet.
• Check to be sure that brewer is plugged in securely.
• Plug into a different outlet.
• Reset your home circuit breaker, if necessary.
• If the brewer still does not operate, contact Customer Service.
• Under normal operation, the BREW Button will flash red when the brewer is heating and
will turn solid red when brewing. If the BREW Button flashes red longer than 3 minutes,
contact Customer Service.
• If the Add Water Indicator does not flash blue, make sure the brewer has power (see above).
• Water may be in the Cold Water Reservoir and brewer. First, try raising the Handle to
drain all water from the Cold Water Reservoir into the brewer. If the light still does not flash,
power off and place a mug on the Drip Tray. Hold down the BREW Button and continue to
hold down until all the water is dispensed into the mug.
• If the brewer still does not operate, contact Customer Service.
• Make sure the brewer has power (see above).
• If using reverse osmosis or distilled water, the brewer may not operate correctly. See page 14 for
emptying the Internal Hot Water Tank and then use filtered or bottled water.
• Press the Power Button. If the Add Water Indicator flashes blue, add water and attempt
to brew. If the brewer loses power during the brew process, the brewer may need to be
reset when power is restored. To reset, simply lift and lower the Handle.
• Check that the minimum water level of 6 oz. has been poured into the Cold Water Reservoir.
16

Advertisement

Table of Contents
loading

Table of Contents