General; First Commissioning/Program Settings - RIKA INTEGRA II Instruction Manual

8. DEVICE COMMISSIONING / CONTROL PROGR AMMING / CONTROLOTIONS

GENERAL

● Check that the pellet container is full and the
combustion chamber is clean and contamination
free.
CAUTION: During the ignition process the grate door
must be closed. The electronic ignition does not work
if the grate door is open.
When the pellet container of the stove is filled for the
first time, no pellets are conveyed to the fire tray for
about 10 minutes. You can put a handful of pellets in
the fire pan to avoid a new start process.
FIRST COMMISSIONING/
PROGRAMME SETTINGS
After filling the supply container and connecting the
stove to the mains electrical supply, press the
ON/OFF key on the internal operating unit and SB
(Standby) is displayed.
"SB" = standby operation
Now program your control for your individual
requirements as follows: (See page 29 for menu
navigation). Two heating
programmed for each weekday. No heating times
are programmed in the factory. Press "MENU" on
the operating unit and the display shows the
following:
"MO" = Monday
intervals can be
- 15 -
Now press "ENTER" and the display shows:
"S1" = start first heating time, 6 the
number is the time in hours (0 to 23
hours) e.g. see window 6 Hour.
By pressing the "+" or "-" keys the heating time can
be changed in hourly steps as required. The desired
value is confirmed with "ENTER" and is then saved.
The display shows
"E1" = end of first heating time,
By pressing the "+" or "-" keys the heating time can
be changed in hourly steps as required. The desired
value is confirmed with "ENTER" and is then saved.
The display shows
"S2" = start of second heating
time,
After entering the second heating time and
confirming with "ENTER" the display shows
"E2" = end of second heating time,
After entering the switch off point of the second
heating time and confirming with "ENTER" the new
valued is saved and the display now shows: