Battery Installation; Remote Controller Mode Switch - Kenwood KDV-412 Instruction Manual

Dvd receiver

Table of Contents

• Put the Remote Controller in a place where it will not move during braking or other operations. A dangerous situation could

result, if the Remote Controller falls down and gets wedged under the pedals while driving.

• Do not place the battery near an open flame or heat source. This may cause the battery to explode

• Do not recharge, short, break up or heat the battery or place it in an open fire. Such actions may cause the battery to leak

fluid. If spilled fluid comes in contact with your eyes or on clothing, immediately rinse with water and consult a physician.

Place the battery out of reach of children. In the unlikely event that a child swallows the battery, immediately consult a

physician

Battery installation

Using a pen tip or similar object, open the battery

compartment in Direction

(as shown) while

unfastening the lock in Direction

(as shown).

Insert the lithium battery (CR2025) supplied,

making sure the polarities are correct. (See the

illustration inside the battery compartment.)

If the Remote Controller operates only over shorter

distances or does not operate at all, it is possible that the

lithium battery is depleted. In such instances, replace the

battery with a new one.

KDV-412

Remote Controller mode switch

The functions operated from the remote

controller differ depending on the position of the

mode switch.

• The position of the remote control mode switch is

indicated in the title of each mode, e.g., "(AUD mode)"

When controlling a player that is not integrated in the

unit, select "AUD" mode.

Table of Contents