Uconnect™ Voice Command - RAM 3500 User Manual

Mute (Or Unmute) Microphone During Call
• During a call, press the "Voice Command" button
• (After the BEEP), say "mute" (or "mute off").
Transfer Ongoing Call Between Handset And Vehicle
• During a call, press the "Voice Command" button
• (After the BEEP), say "transfer call".
Changing The Volume
• Start a dialogue by pressing the "Phone" button
during a normal call.
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a
comfortable level while the Uconnect™ system is speaking. Please note the
volume setting for Uconnect™ is different than the audio system.
• Any voice commanded system should be used only in safe driving
conditions following local laws and phone use. All attention should be
kept on the roadway ahead. Failure to do so may result in a collision
causing you and others to be severely injured or killed.
• In an emergency, to use Uconnect™ Phone, your mobile phone must be:
• turned on,
• paired to Uconnect™ Phone,
• and have network coverage.
Uconnect™ VOICE COMMAND
• The Uconnect™ Voice Command system allows you to control your AM, FM
radio, satellite radio, disc player, HDD, Uconnect™ Phone, a memo recorder,
and supported portable media devices.
• When you press the "Voice Command" button
faceplate or steering wheel, you will hear a beep. The beep is your signal to
give a command. If you do not say a command within a few seconds, the
system will present you with a list of options. If you ever wish to interrupt the
system while it lists options, press the "Voice Command" button
for the BEEP, and say your command.
WARNING!
Voice Command Operation
• Start a dialogue by pressing the
"Voice Command" button
you will hear a beep. The beep is
your signal to give a command.
Below are a list of voice commands
for each of the different modes.
ELECTRONICS
.
.
, then adjust the volume
located on the radio
, listen
,
47