Error Discs - Epson PP-100II User Manual

❏ Ink may not bond if printed outside the receptor.
❏ If the product is operating, wait for 10 seconds after the operation is finished, and then
turn the power off.
❏ Data may be lost depending on the disc or storing condition; therefore, store important
data on multiple discs. Epson does not guarantee the data against loss.
❏ Do not insert a disc between drive 1 and drive 2, as you may not be able to remove it.
❏ Do not insert an object like a screwdriver or clip into the drive slots as this may cause a
malfunction.
❏ A published CD/DVD/BD may not be readable on another type of drive or player due to
compatibility.
❏ The quality of the blank disc determines print and write/read quality. It is recommended
to use only the specified disc type.
❏ It is recommended that you run a compare while writing data.
❏ Making a backup is recommended if the data is important. Recorded data may degrade
over long storing periods. It is recommended to make backups periodically.
❏ Do not shock or vibrate the product while reading or writing, as this may result in
malfunction of the drive or make the disc unusable.
❏ Do not use a cracked, warped, or deformed disc because it may break in pieces inside
the product and cause malfunction or injury.
❏ A disc may become unreadable or unwritable if it has a small scratch or dirt; therefore,
please handle it with care.
❏ Hold disc by the edge, and do not touch either surface.
❏ The completed job display of EPSON Total Disc Monitor shows the number of
successes, number of failures, and number of discs printed.
❏ Do not use discs with lens cleaner, a label sticker, or condensation on them as it may
cause mechanical error or malfunction.
❏ If the file system of the computer used is FAT, DVD/BD writing may not be possible.

Error Discs

Discs with write/read error will be ejected to different stackers depending on the output
stacker.
29
Publishing Discs