Assembling The Vacuum Cleaner - VOLTA Contour Gen 3 U4210 Instruction Manual

PRECAUTIONARY MEASURES
If the suction air flow is blocked, you should switch
off the vacuum cleaner at once. First clear the
blockage from the hose and/or telescopic extension
tube before you attempt to start the vacuum
cleaner again.
1. Do not operate the vacuum cleaner too close
to heaters and like radiators, cigarette butts etc.
2. Before you insert the plug into the power
socket, make sure your hands are dry.
3. Before you start using the vacuum cleaner,
please remove large or sharp objects from
the floor in order to prevent the paper
bag to be damaged.
4. When you want to pull the plug form the power
socket, please do this at the plug itself and not
by the means of the electrical cable.
This vacuum cleaner is equipped with a cable and
plug, which rolls up on activation of the rewind
pedal. If the plug or cable is damaged, the plug and
cable assembly must be replaced by returning the
product to your local Electrolux Service Provider in
order to avoid a hazard.
35121_U4210-U4214_IFU_V3.indd 4

ASSEMBLING THE VACUUM CLEANER

ASSEMBLING VACUUM CLEANER
Always remove the plug from the power socket
before fitting or removing accessories!
Fitting or removing the flexible
hose Fitting:
Insert flexible hose into the air intake duct on the
top of appliance. Press until it clicks into position.
Removing:
Remove the plug form the power socket.
To release the flexible hose, press firmly the two
release buttons on the hose sleeve and remove
the hose from the air intake duct.
Fitting the tube set and accessories
Fit the tube set to the bent end handle.
Fit the floor nozzle to the extension tubes.
3.
2/10/08 2:13:08 PM