Maintenance; Cleaning Filter - VOLTA Contour Gen 3 U4210 Instruction Manual

1. After removing the hose, open
the front cover.
2. Raise the support of the bag to an
upright position.
3. Remove the dust bag.
4. In case of paper bag.
Replace the paper bag with new when it is
full of dust or dust bag indicator shows red.
In case of cloth bag
Follow the above 1,2,3 steps
To open, slide the plastic clip off the bag
Empty bag and refit the plastic clip
Note: The cloth bag may be washed in lukewarm
water and dried completely. It should not be washed
in washing machine.
5. Close the cover by pressing down until it
is locked
6. *Note: A cloth bag is not supplied with this
product. To purchase a cloth bag, please return
to the place of purchase or contact Electrolux
on 1300 365 305 (Aus), 0508 730 730 (NZ).
WARNING:
On collection of proprietary carpet conditioning
powders, plaster / concrete dust, it is
recommended that the dust bag is changed.
35121_U4210-U4214_IFU_V3.indd 6

MAINTENANCE

Some of the preparations contain substances
which while left in the vacuum cleaner for
extended periods could create damage.
Many air fresheners, household deodorants,
sprays and polishes contain highly inflammable
gas propellants. Because of this it is particularly
important that these products are used strictly
in accordance with the relevant manufacturers
instructions. It is essential that none of the above
products are sprayed directly into the vacuum
cleaner or any of the filters, hose assembly or
dust chamber

Cleaning filter

• Filter should be cleaned at least twice a year
or when it becomes visibly dirty.
• Always operate the cleaner with filter installed,
otherwise reduced suction or motor damage
may result.
• Disconnect from electrical outlet, before
cleaning the filter.
• Do not use a washing machine to rinse filter.
• Do not use hair dryer to dry it.
1. Pull dust bag by pulling dust bag collar
upwards.
2. Remove filter from holder.
3. Rinse filter in lukewarm water and dry the
filter completely.
4. Put back filter into the filter holder and refit.
Changing the Micro-exhaust filter
1. Open the Air-Outlet Filter Grille by pressing the
grill latch and pull out.
2. Take the filter out and replace with a clean filter.
3. Close the Air-Outlet Filter Grille.
4. To purchase new filters, contact Electrolux
on 1300 365 305 (Aus), 0508 730 730 (NZ).
5.
2/10/08 2:13:16 PM