Description; Figure 3: Component Descriptions And Locations - Jet VSF-14-1 Operating Instructions And Parts Manual

Description

1. CONTROL PANEL – The operating controls for the band saw are located on the base at the
front of the machine.
1.1. ON/OFF SWITCH – Turns the machine on or off.
1.2. SAW FRAME RELEASE KNOB – Turning this knob counterclockwise unlocks the
release lever (Item 2).
1.3. FEED RATE ADJUST KNOB – Used to adjust the hydraulic feed control rate.
2. SAW FRAME RELEASE LEVER – Pull up on this lever to release the saw frame after
unlocking it (Ref Item 1.2) and push down to return the saw frame to its rearmost position.
3. BLADE TENSION HANDLE – Used to set the correct blade tension. Also used to remove and
install the saw blade.

Figure 3: Component Descriptions and Locations

9