Bowflex Ultimate 2 Assembly Instructions Manual page 14

13
STEP 4
Parts:
• Base Assembly (from step 3)
• Front & Rear Plastic Base Covers
Tool:
• Hex Key (7/32")
4-1 Position Plastic Covers on Front and
Rear Base Platforms.
4-2 Install and completely tighten the hardware.
Hardware (1:1):
9 Button Head Screws (1/4" X 1/2")
STEP 5
Parts:
• Base Assembly
• Front Base Plate
• Front Base Feet (4)
Tools:
• Wrench (5/16") • Phillips Head Screwdriver
5-1 Fold the front base assembly into the
upright position.
5-2 Position the Base Plate and secure with
eight Phillips Head Screws and Washers.
5-3 Position the four Base Feet and secure with
Hex Washer Head Screws. Do not over tighten.
Feet could crack with excess pressure!
5-4 Completely tighten the Base Plate hardware.
Hardware (1:1):
8 Pan Head Phillips Screws (#8 X 3/4")
Assembling Your Bowflex Ultimate
Front Plastic Cover
9 Washers (1/4")
Hex Washer Head Screw
8 Washers (#8 )
Button Head
Screw
Washer
Base Plate
Phillips Head Screw
Base Foot
4 Hex Washer Head Screws (#10 X 3/4")
™
2
Rear Plastic Cover
Washer