Using The Lsi Logic Configuration Utility Program - IBM eServer xSeries 345 Type 8670 User Manual

Assist will start, and information about the tree object will appear in the right pane.

Using the LSI Logic Configuration Utility program

You can use the built-in, menu-driven LSI Logic Configuration program to:
v Perform a low-level format on a hard disk drive
v Set the SCSI device scan order
v Set the SCSI ID for a controller
Notes:
1. The integrated SCSI controller with RAID capabilities in your server supports
2. If your server has a ServeRAID-5i controller installed, you can use ServeRAID
Complete the following steps to start the LSI Logic Configuration Utility program:
1. Turn on the server and watch the monitor screen.
2. When the Press CTRL C to start LSI Logic Configuration Utility prompt
3. Use the arrow keys to select a controller (channel) from the list of adapters;
4. Follow the instructions on the screen to change the settings of the selected
RAID level 1 operation.
Manager to configure the integrated SCSI controller with RAID capabilities for
additional RAID levels.
appears, press Ctrl+C.
Note: If an administrator password has been set, a prompt appears asking you
to type the password to start the LSI Logic Configuration Utility program.
then, press Enter.
items; then, press Enter.
Chapter 2. Configuring your server
27