3.6.2 PTZ Setting
Camera Protocol
Note: please DO NOT change the default value if unnecessary. If so, user needs to check
and set value properly for both sides.
Camera Address
Baud rate
Note If need to change these parameters, user needs to check and set value properly for
both, network module and P/T scanner.
OSD Control
OSD Open
OSD Close
OSD Select
OSD Back
OSD Up
This device can connect to a PTZ camera or speed dome camera
and controls them thru RS-485 interface.
This is the camera ID set in PTZ camera or speed dome camera.
This is the communication speed between network module and P/T
scanner.
Choose the corresponding model for OSD control
Control commands for Open function.
Control commands for Close function.
Control commands for Select function.
Control commands for Back function.
Control commands for Up function.
48