Hunter 42856-01 Owner's Manual And Installation Manual page 12

7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Installing the Glass Bowl
7-8. First install included B10 (60 Watts Maximum) bulbs into the
sockets.
7-9. If the fandangle is attached to the extra pull chain, remove it now.
7-10. Attach the extra pull chain (included) to the fan pull chain using
the plastic breakaway connector. (You may find the plastic
breakaway connector on the end of the extra chain.)
7-11. Thread the fan pull chain through the hole in the metal disc. Then,
thread the fan pull chain through the hole in the center of the glass
bowl.
7-12. Thread the light pull chain
through the hole in the center of
the glass bowl. Then, Thread the
light pull chain through the hole
in the center of the cover plate.
7-13. Thread the fan pull chain through
the grommet hole in the side of
the cover plate.
7-14. Place the cover plate up against
the glass bowl. Align the holes in
the cover plate and glass bowl.
7-15. Thread the light pull chain
through the finial and screw the
finial onto the threaded rod end
until tight.
7-16. Reattach the fandangle to the
extra pull chain.
12
42856-01 • 01/30/09 • Hunter Fan Company
Breakaway
Connector
For Light Bulbs
Metal Disk
Metal Rod
Glass Bowl
Cover Plate
Finial