Page 1
Coppell, TX 75019 EE.UU. (800) 486- 4892 8:00 a 5:00 CST (Hora local central) Número de fax sin cargo: (877) 304-1728 Installation Instructions Correo electrónico: customerservice@craftmade.com www. craftmade.com Instrucciones de instalación Instructions d’installation UNE CONCEPTION EXCEPTIONNELLE P. O. Box 1037 650 S.
Page 2
Before Assembly Read and Save ese Safety Precautions 1. Make sure that the fan voltage (120) is compatible with your own electrical 1. Turn off electricity at main switch before wiring or servicing fan in order to system. avoid possible electrical shock. 2.
Page 3
Installing Mounting Bracket Turn off circuit breakers and wall switch to the fan supply line leads. Important: When using an existing outlet box, be sure the box is Preparation securely attached to the building structure and can support the full weight of the fan.
Page 4
Downrod Assembly read the downrod onto the motor housing making sure the wires don’t get twisted. Locate downrod assembly (#2). Loosen ball screw on black hanging ball to Insert saftey bolt (S7) through flange & downrod free lock pin. Black hanging ball will slide down. Remove ground screw and and attach nut.
Page 5
Place flange cover (4) over downrod assembly. Place canopy (3) over downrod (2). WARNING: Failure to completely tighten downrod as described in steps above could result in the fan loosening and possibly falling. Lift fan onto the mounting bracket (#1). Turn housing until hanging ball seats itself into ball socket (listen for click).
Page 6
Ground 1. Connect fan wires to ceiling Wire White (Neutral) Connectors wires: white fan wire to white (S6) outlet wire, black to black and Black (Power) green to green. Wire connectors (S6) are provided for your conve- Ground White (Green) nience.
Page 7
Remove switch housing plate cover by unscrewing the two set Remove rubber shipping grommets screws and twisting the unit to before attaching blade assembly. release the locking screws. Position the switch housing plate on the motor housing and thread For blade assembly, position slot on wires through the center and attach fan motor housing so that you can securely using supplied screws.
Page 8
Trouble Shooting Problem A: Fan Will not Start Remedies: 1. Check fuse or circuit breaker and replace if necessary 2. Turn off electrical power and check all wire connectors. 3. Check on/off TCS and wall control selector switch. See operation instructions.
Need help?
Do you have a question about the Epic DCEP70 and is the answer not in the manual?
Questions and answers