Yamaha VX110 Sport Service Manual page 52

INSP
ADJ
c
CONTROL SYSTEM
d
2. Adjust:
• Steering cable joint
(steering column end)
Adjustment steps:
• Set the control grip to the neutral posi-
tion.
• Loosen the locknut 1.
• Disconnect the cable joint 2 from the ball
joint 3.
• Turn the cable joint 2 in or out to adjust
the steering cable length c.
Steering cable length c:
218.8 mm (8.61 in)
NOTE:
• Check that the sum of lengths c and d is
581.8 ± 1 mm (22.91 ± 0.04 in).
• If the sum of lengths c and d is out of
specification, adjust length d, and then
check the jet thrust nozzle distances
again.
WARNING
The cable joint must be screwed in more
than 8 mm (0.31 in).
• Connect the cable joint and tighten the
locknut.
Locknut:
6.8 N • m (0.68 kgf • m, 4.9 ft • lb)
NOTE:
Adjust the cable joint at the jet pump end.
Refer to "REMOTE CONTROL CABLES AND
SPEED SENSOR LEAD" in Chapter 8.
3-3
E