Cam Position Sensor - Yamaha VX110 Sport Service Manual

Yamaha waverunner service manual
Table of Contents

Advertisement

+
ELEC
A
B
C
IGNITION SYSTEM
1
2

CAM POSITION SENSOR

1. Measure:
• Cam position sensor output voltage
Out of specification → Replace.
Test harness (3 pins):
New: YB-06877
Current: YB-06777
Test harness HM090-3 (3 pins):
New: 90890-06877
Current: 90890-06777
Cam position sensor output
voltage:
Green/orange (G/O) –
Black/orange (B/O)
Position
A
B
C
Measurement steps:
• Remove the cam position sensor.
• Connect the test harness to the cam
position sensor.
• Operate the Yamaha Diagnostic System.
• Pass a screwdriver under the cam posi-
tion sensor in the direction shown and
measure the output voltage.
NOTE:
• The cam position sensor consists of two indi-
vidual sensors as shown in the illustration:
sensor 1 1 and sensor 2 2.
• To measure the output voltage, pass a
screwdriver under the cam position sensor at
measuring points A, B (center), and C in this
order.
• When operating the Yamaha Diagnostic Sys-
tem, electric power is supplied to the cam
position sensor.
7-29
E
Voltage (V)
More than 4.8
Less than 0.8
More than 4.8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Waverunner vx110 sport

Table of Contents