Assembling The Blades And Hanging The Fan - Hunter 41897-01 Installating And Operation Manual

5 • Assembling the Blades and Hanging the Fan
8
Blade Iron
Mounting Screw
Grommet
Medallion
Hunter Fan Company
Note: If available, use a magnetic tip screwdriver.
5-1. Insert the grommets into the holes in the blades.
5-2. Attach each blade to the blade iron and medallion using the three
blade assembly screws. Insert the assembly screws into the blade
iron, through the blade and into the medallion, with the blade
captured between the blade iron and medallion. e blades may
appear slightly loose after the screws are tightened. is is normal.
5-3. Remove the blade iron mounting screws from the motor. Discard
the shipping blocks and save the screws.
5-4. Partially install one blade iron mounting screw through a blade
iron and into the motor. Insert a second blade iron mounting
screw, then securely tighten both screws.
5-5. Raise the fan and place the hook on the ceiling plate through the
U-shaped hole in the rim of the canopy.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Steps 5-1 – 5-4
Blade Assembly
Screw
Step 5-5
41897-01 • 11/22/05
U-shaped
Hole