CycleOps Club IC Service Manual page 12

Main Menu
Time and Date
Modes
Coded Sensor ID
Return
RESET
STATS
Modes
Comp Mode PT300
Record Cntr Speed
Language English
Backlight UI Data
Reset
Return
RESET
STATS
Setup Modes 1
1) From [MAIN MENU] press [DOWN ARROW] to scroll
to through to [SETUP] and press [STATS].
2) Press [STATS] to enter [MODES].
Setup Modes 2
3) Press [DOWN ARROW] to scroll to [COMP MODE] and press [STATS].
4) Press [DOWN ARROW] to toggle between [200E] or [PT300]. Select setting
depending CycleOps Indoor Cycle model you own. Press [STATS] to accept
changes and reenter scrolling menu.
5) Press [DOWN ARROW] to scroll to [RECORD CNTR] and press [STATS].
6) Press [DOWN ARROW] to toggle between [SPEED] and [HEART]. Press
[STATS] to accept changes and reenter scrolling menu. This function sets
when the ride time clock auto starts and stops. In [SPEED] mode, the run time
clock will stop when speed reaches zero. In [HEART] mode, the run time clock
time will continue to record as long as heart rate signal is detected.
7) Press [DOWN ARROW] twice to scroll to [BACKLIGHT] and press [STATS].
8) Press [DOWN ARROW] to select either [UI], [UI DATA] or [OFF]. This function
determines when the backlight will be illuminated. [UI] = User Interface (when
buttons are pushed), [UI DATA] = User Interface and Data input, [OFF] =
Backlight is never illuminated. Press [STATS] to accept changes and reenter
scrolling menu.NOTE: Use of backlight will reduce battery life.
9) To reset user settings select press [DOWN ARROW] and press [STATS].
10) Press [DOWN ARROW] to scroll to [RETURN] and press [STATS] to return to
[MAIN MENU].
11