Power Outlet - Chrysler 300 includes srt8 2010 User Manual

• Your motorized door or gate will open and close while you are training the
universal transceiver. Do not train the transceiver if people or pets are in the
path of the door or gate. Only use this transceiver with a garage door opener
that has a "stop and reverse" feature as required by Federal safety standards.
This includes most garage door opener models manufactured after 1982. Do not
use a garage door opener without these safety features. Call toll-free
1–800–355–3515 or, on the Internet, at www.HomeLink.com for safety
information or assistance.
• Vehicle exhaust contains Carbon Monoxide (CO), a dangerous gas. Do not run
your vehicle in the garage while training the transceiver. Exhaust gas can cause
serious injury or death.
NOTE: If you are having difficulty training your HomeLink
was manufactured after 1995, you may have a rolling code system. Follow the steps
below for programming a rolling code system.
Programming A Rolling Code System
• At the garage door opener motor (in the garage), locate the "learn" or "training"
button. This can usually be found where the hanging antenna wire is attached to
the garage door opener motor (it is NOT the button normally used to open and
close the door).
• Firmly press and release the "learn" or "training" button. The name and color of
the button may vary by manufacturer. Within 30 seconds, return to the vehicle and
press the programmed HomeLink
seconds each time). If the device is plugged in and activates, programming is
complete.
• If the device does not activate, press the button a third time (for two seconds) to
complete the training.
®
Using HomeLink
• To operate, simply press and release the programmed HomeLink
trained device will operate.
• Refer to your Owner's Manual on the DVD for further details. If you have any
problems programming HomeLink
1–800–355–3515, or on the Internet, at www.HomeLink.com.

POWER OUTLET

• There are two 12 Volt electrical outlets on this vehicle.
• The outlet on the front console has power available only when the ignition is in the
ON position. If desired, this outlet can be converted by your authorized dealer to
provide power with the ignition switch in the LOCK position.
ELECTRONICS
WARNING!
®
button twice (holding the button for two
®
, or require assistance, please call toll-free
39
®
and your garage door
®
button and the